top of page

Harness Stick Manual

1. Manual :  Harness Stick / (harness mount)  Inox (AISI 316) 
0.jpg

             Correct way of  mounting 

2.jpg

Basic Parts

1.1.jpeg
3.jpg

Thread Locker 
("light" or "medium strength" 
already is applied on
M12  bolt (central bolt)


Also : a "washer" and a
"safety washer" are inserted
on the bolt
 

0_tighten.jpeg

Tight securely with a screw driver before every session

Top Trident : 
a. Thread locker (light or medium strength ) is applied on the female thread.
b. Additionally : These elastic flanges are used to produce a "pretension" on the top connetion  , so together with the thread locker ,  the camera with not rotate  during the session.

4.jpeg
5.jpg
8_Trident
2. Manual :  Harness  Stick  - Thermoplastic version
th_8.jpg

             Correct way of  mounting  

th_7.jpg

Safety rope

Possible angle positions (inclination) of the stick : 
From horizontal  (0° degrees)   , to 
vertical position (90° degrees)

20221023_214444.1.jpg
th_13.jpg

With the Allen key (8mm)  you can :
1. Adjust the "inclination" (from 0° to 90° degress) of the carbon stick  
and  (see 2.)

 

th_12.jpg


2. Regulate the tightness of  the carbon stick  inside the "female" pocket   
(diameter D14mm).

th_11.jpg

Top Trident : 
a. Thread locker (light or medium strength ) is applied on the female thread.
b. Additionally : These elastic flanges are used to produce a "pretension" on the top connetion  , so together with the thread locker ,  the camera with not rotate  during the session.

4.jpeg
5.jpg
8_Trident
bottom of page